Meter Runs

Meter Runs - Prisma Request a quote

Meter Runs

Meter runs are supplied as a complete unit of normally 1M length to ensure the necessary straight pipe length to achieve highest possible efficiency. These are available with line sizes mostly below 50mm with corner tap. These are used for the measurement of small flow rates precisely where high accuracy of flow rates is required.

 

Types of Meter Runs

  • Orifice Flange union with Meter -run.
  • Orifice flange union with Carrier ring & Meter -run.

Generally Meter-run pipe is recommended with upstream length of 750mm and downstream length of 250mm. Meter runs sizes above 50mm are also available as per the customers or process requirements.

 

MOC

Orifice Plate in SS 316, SS 304 & other onrequest.

 

End Connection

Socket Weld, Screwed andFlanged ends with meter run piping suitable toANSI, IS & DIN flanges

  • Features
  • Datasheet
  • Informations

Spécifications

Design
Conforms to ISA RP 3.2 , DIN 1952 , BS 1042, ISO-5167

Types
Square edge concentric, Quadrant edged, Conical entrance, Eccentric, Segmental

Plate material
SS304 , SS316 , SS316L as standard. Hastelloy-C , Monel , PP , PVC , PTFE coated , etc. can be given on request.

Orifice Bore
In accordance with ISO-5167, BS-1042, ASME MFC 3M, R.W.Miller, L.K.Spink, AGA-3

Tab Plate
In the same material as plate & is welded to orifice plate. Tab plate integral to the Orifice plate (i.e. without welding) can also be offered as a special case.

Vent / Drain
Vent or Drain holes are provided as per customer's requirement. The diameter of the vent or drain holes are as per ISA RP 3.2

Flange Union Weld neck, Slip on, Threaded, Socket welded with RF or RTJ facing Orifice flanges are in accordance with ANSI B16.36 with minimum flange rating of 300# for sizes up to 8" or male - female flanges in accordance with ANSI B16.5

Pressure Tappings
Corner tappings are recommended for sizes upto 1 ½"; Flange taps from 2" to 16" ; D - D/2 taps for higher sizes

Gasket

CAF as per IS: 2712 Gr 0/1 , SS spiral wound + CAF , SS spiral wound + Grafoil, SS spiral wound + PTFE are normally supplied as per process requirement. Other materials available on request. For RTJ flanges , the plate is fixed on the plate holder. The plate holder is in Soft Iron material & acts as a gasket.

 

Studs / Nuts ASTM A193 Gr.B7/A-194 Gr.2H as standard, Other material on request.

Jack Screw ASTM A193 Gr.B7/A-194 Gr.2H as standard, Other material on request.

Download the datasheet répéteur RS422/485

You want to get a quote, please click on the link and fill in the form. Note that our prices are digressive according to quantities.

 

For more information or any specific request, please contact our services. We shall get back to you as soon as possible.